Sorry to pop in here just to clarify this is the driver side temperature actuator and the easiest out of 4 actuators.
2005 chevy silverado driver side blend door actuator location.
Driver side actuator for blend door is electric servo controlled.
Once the panel is off simply loosen the actuator mounting screws and disconnect it from the hvac system.
2005 chevy 1500 with dual climate control.
After diagnosing a faulty passenger side blend air door actuator with a tech 2 scan tool it was time to remove the dash cover.
I need to replace the temp door actuator on the drivers side.
Not a big deal but there are a lot of steps.
The recirculation door actuator is sitting a bit higher to the right the mode door actuator is accessible from the driver side and the passenger side temperature actuator my favourite is on top of the heater box and a real pleasure to replace.
Unit is located on driver side of heater case.
I read up that this could possibly be caused by a faulty or stuck blend door actuator but i ve read conflicting posts on where this actuator could be located.
Begin by identifying the problem either defrost mid or floor or temperature modes not working.
This 2004 chevrolet silverado came in with multiple hvac actuator faults.
Does anyone have a picture or diagram of where the actuator is located.
2005 chevy silverado passenger side door blend actuator replacement.
These units can be either hanging in front of you or in a little more obscure places such as on the side the hvac plenum.
I have a 2005 yukon xl and the drivers side air is blowing hot independent of what the climate control is set to while the passenger side is blowing the correct temperature.
The driver side blend door is accessed by removing the ip instrumental panel.
The hvac is only blowing hot in the front and not cold but the ac compressor is turning on so i believe it is the blend door actuator because i.
Blend door actuator locations.
It could be jammed or computer sending it in wrong direction.